9
SETTING THE BEEP SYMBOL
The Blood Pressure Monitor automatically stores up to 60
measurement values with the date and time. The monitor also
calculates an average reading based on the last three measurements
taken within 10 minutes of the last reading.
NOTE:
• If only two readings are stored in the memory for the
10-minute period, the average is based on the two
readings.
• If one reading is stored in the memory for the 10-minute
period, this reading is displayed as the average.
1.
Press the SET button.
The Beep Symbol “on”/ “oFF” will appear.
Press the MEM button to adjust.
Press SET button to set mode.
The year flashes on the display.
HEM-629-IM-US-8094 9/27/05 4:09 PM Page 9
To Next Page
Loading...
Need help?
General
