20
4. Troubleshooting and Maintenance
4. Troubleshooting and Maintenance
4.1 The Icons and Error Messages
Error Display Cause Remedy
Irregular heartbeats are
detected.
Remove the arm cuff. Wait 2-3
minutes and then take another
measurement.
Repeat the steps in section 3.3. If
this error continues to appear,
contact your doctor.
Movement during
measurement.
Carefully read and repeat the steps
in section 3.3.
Cuff is not applied
correctly.
Apply the arm cuff correctly.
Refer to section 3.1.
The batteries are low.
You should replace them with new
ones ahead of time.
Refer to section 2.1.
The batteries are
exhausted.
You should replace them with new
ones at once.
Refer to section 2.1.
Air plug disconnected.
Insert the plug securely.
Refer to section 3.1.
Arm cuff not applied
correctly.
Apply the arm cuff correctly.
Refer to section 3.1.
Air is leaking from the arm
cuff.
Replace the cuff with the new one.
Refer to Chapter 5.
Blink
Lit
HEM-7211-C1_B_M.book Page 20 Tuesday, April 27, 2010 4:00 PM
To Next Page
Loading...
Need help?
General
