20
5. Push the START Button to start the
measurement.
• Do not push the
START Button without
wrapping the cuff.
• If you want to stop
measurement, push
the STOP Button. The
cuff will rapidly
deflate.
6. The measurement results are
displayed.
• While the battery pack is in use, the
monitor will turn off automatically after
five minutes of inactivity and the display
(measurement results) will disappear.
(Automatic Power Off)
7. Push the ON/OFF (power) Button to
turn off the power.
If the monitor determines that the pressure value is not correct,
an error display appears (Er1 to 9). In this case, refer to Page
27 and start the measurement again.
HOW TO MEASURE
BLOOD PRESSURE
(IN SINGLE MODE)
HEM-907-Z2_E_M.qxd 09.8.28 11:45 AM Page 20
To Next Page
Loading...
Need help?
General
