23
3.Using the Unit
EN
3.5
Using the Memory Function
This unit has a memory capable of storing 42 sets of readings.
Every time you complete the measurement, the unit
automatically stores the blood pressure and pulse rate.
If there are three readings within 10 minutes of the last reading,
the average of the three readings is displayed. (If there are only
two readings in memory for that period, the average will be
based on two readings. If there is only one reading in memory
for that period, that reading will be displayed as the average
value.)
Note:
When 42 sets of readings are stored in memory, the
oldest set will be deleted to store a new set.
1.
Press the MEMORY button.
If there are three readings stored in
memory that were taken within 10
minutes of the last reading, an
average value for those reading is
displayed. (If there are only two
readings in memory for that period, the average will be based
on two readings. If there is only one reading in memory for that
period, that reading will be displayed as the average value.)
Note:
If there are no measurements results stored in
memory, the screen to the right is displayed.
HEM-7051_E_main.book Page 23 Friday, August 29, 2008 11:24 AM
To Next Page
Loading...
Need help?
General
