Omron NX502-1 Series Manual

Machine Automation Controller NX1
31
*1. To use Safe Mode, set the DIP switch as shown below and then turn ON the power supply to the Controller.
If the power supply to the Controller is turned ON with the CPU Unit in Safe Mode, the CPU Unit will start in PROGRAM mode. Use the Safe
Mode if you do not want to execute the user program when the power supply is turned ON or if it is difficult to connect the Sysmac Studio.
For information on Safe Mode, refer to the NJ/NX-series Troubleshooting Manual (Cat. No. W503).
*2. Refer to the NJ/NX-series CPU Unit Software User’s Manual (Cat. No. W501) for details on backing up data.
NX Unit Configuration
CPU Rack
The CPU Rack consists of an NX-series NX102 CPU Unit, NX Units, and an End Cover.
Up to 32 NX Units can be connected.
QEnd Cover
A cover to protect the NX Unit and CPU Unit.
One End Cover is provided with the CPU Unit.
R DIN Track contact plate This plate is used to contact the functional ground terminal with a DIN Track.
Series Configuration Remarks
NX-series
NX-series NX102 CPU Unit One required for every CPU Rack.
End Cover
Must be connected to the right end of the CPU Rack. One End Cover is provided with
the CPU Unit.
NX Units
Digital I/O Unit
Up to 32 Units can be mounted to each CPU Rack.
Refer to NX-series NX102 CPU Unit Hardware User’s Manual (W593) for information
such as restrictions on the NX Units.
For information on the most recent lineup of NX Units, refer to NX-series catalogs or
OMRON websites, or ask your OMRON representative.
Analog I/O Unit
System Unit
Position Interface Unit
Communication Interface Unit
Load Cell Input Unit
NJ/NX-series SD Memory Card Install as required.
Letter Name Function
OFF
ON
O
N
1
2
3
4
NX-series
NX102 CPU Unit
SD Memory Card
End CoverNX Units
(32 Units max.)

Omron NX502-1 Series Specifications

General

Brand	Omron
Model	NX502-1 Series
Category	Controller
Language	English