Machine Automation Controller NX1
9
Position Interface: Pulse Output Units
*1. This is the number of pulse output channels.
*2. Unit version 1.2 or later and an NX-ECC203 EtherCAT Coupler Unit are required.
Communications Interface Units
RFID Units
IO-Link Master Unit
Product Name
Specifications
Model
Number of
channels *
1
External inputs
External
outputs
Maximum
pulse output
speed
I/O refreshing
method
Number of
I/O entry
mappings
Control
output
interface
Pulse Output Unit
1 (NPN) 2 (NPN) 1 (NPN)
500 kpps
Synchronous I/O re-
freshing, Task period
prioritized refreshing *
2
1/1
Open collector
output
NX-PG0112
1 (PNP) 2 (PNP) 1 (PNP) NX-PG0122
2
5 inputs/CH
(NPN)
3 outputs/CH
(NPN)
4 Mpps
2/2
Line driver out-
put
NX-PG0232-5
5 inputs/CH
(PNP)
3 outputs/CH
(PNP)
NX-PG0242-5
4
5 inputs/CH
(NPN)
3 outputs/CH
(NPN)
4/4
NX-PG0332-5
5 inputs/CH
(PNP)
3 outputs/CH
(PNP)
NX-PG0342-5
Product Name Serial interface External connection terminal Number of serial ports
Communications
protocol
Model
Communications
Interface Unit
RS-232C
Screwless Clamping Terminal Block 1 port
• No-protocol
• Signal lines
NX-CIF101
RS-422A/485 NX-CIF105
RS-232C D-Sub connector 2 ports NX-CIF210
Product name Amplifier/Antenna No. of unit numbers used Model
RFID Unit (1Ch)
V680 series
1 NX-V680C1
RFID Unit (2Ch)
2 NX-V680C2
Product Name
Specifications
Model
Number of IO-Link ports I/O refreshing method I/O connection terminals
IO-Link Master Unit
4 Free-Run refreshing Screwless clamping terminal block NX-ILM400