EasyManuals Logo
Home>On-Q>Keypad>lyriQ

On-Q lyriQ User Manual

Default Icon
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 4 of 8
INSTRUCTION/INSTALLATION SHEET
lyriQ™ Standard Keypad
IS-0391 REV. D
©Copyright 2009 by On-Q/Legrand All Rights Reserved.
4. Operation
A. ON/OFF:
Keypad – Press any button for ON / Press and hold MUTE
button for OFF (see Figure 5).
Remote – After pressing On-Q button, press On/Off button to
toggle ON or OFF (see Figure 6).
B. SOURCE select:
Keypad – Press SOURCE button multiple times (see Figure 5).
Remote – Press SOURCE UP or DOWN button to select desired
source.(see Figure 6).
NOTE: Upon source change, volume ramps down and then
back up automatically.
C. Volume Steps: Keypad or Remote – Press VOLUME UP or DOWN button
(40 steps for Keypad / 36 steps for Remote).
D. Mute: Keypad or Remote – Press MUTE button to toggle On or Off.
E. Back Light Level Adjust:
Keypad – Press and hold VOLUME UP and DOWN buttons simultaneously. The
button back lights will flash to indicate they may be adjusted. Press VOLUME UP
or DOWN button to adjust back light level. Press SOURCE or MUTE button to exit
or wait for 10 second time out (see Figure 5).
NOTE: When any Keypad button is tapped, back light level goes to full bright and
returns to the adjusted level when activity ceases. For Remote operation, the
back light goes to full bright when an IR command is received and returns to the
adjusted level when activity ceases.
F. Temporary Do Not Disturb (DND):
Keypad – Double tap MUTE button, Status/IR LED glows dim RED (see Figure 5).
NOTE: When Keypad is in temporary DND mode, it will NOT respond to whole
house commands from other locations. Press any button to disable temporary
DND mode.
G. Whole-House Source Control/Party Mode (see Figure 5 and 6):
NOTE: In this mode, every operation performed on this keypad will be
relayed to all keypads in the system.
Keypad – Press the MUTE and SOURCE buttons simultaneously and the
IR/Status LED should blink orange (just press Whole House button on
Remote to toggle function On or Off.).
Figure 5
Figure 6
Source
LEDs
Source
Button
Mute
Button
Volume
Buttons/
LEDs
IR
Target
Status
LED
On-Q
Button
Source
Buttons
Volume
Buttons
Mute
Button
Whole
House
Button
Room
Button
Local
Button
i Button
On/Off
Button

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the On-Q lyriQ and is the answer not in the manual?

On-Q lyriQ Specifications

General IconGeneral
BrandOn-Q
ModellyriQ
CategoryKeypad
LanguageEnglish