69
3
Taking a test
NOTE:
• When you first open a new vial of control solution,
record the discard date on the vial label. Refer to the
control solution insert or vial label for instructions on
determining the discard date.
• Tightly close the cap on the control solution vial
immediately after use to avoid contamination or
damage.
• Do Not open the test strip vial until you are ready to
remove a test strip and perform a test. Use the test
strip immediately after removing it from the vial,
especially in high humidity environments.
• Control solution tests must be done at room
temperature (20-25°C). Make sure your meter, test
strips and control solutions are at room temperature
before testing.
CAUTION:
• Do Not swallow or ingest control solution.
• Do Not apply control solution to the skin or eyes as it
may cause irritation.
• Do Not use control solution after the expiry date
(printed on the vial label) or the discard date,
whichever comes first, or your results may be
inaccurate.
To Next Page
Loading...
Need help?
General
