Onkyo C-705X User Manual

20
Symptom
STANDBY/ON button is pressed,
but power does not come on.
Disc is loaded in the disc tray,
but playback will not begin.
No sound
Disc skipping
Search time (when moving to
a specific track) is extremely
long.
Track numbers cannot be
stored in the memory.
Noise during play
Remote controller does not
function.
Troubleshooting
Remedy
• Insert the plug firmly.
• Load the disc with the label facing
upward.
• Clean the disc.
• Remove the disc from the disc tray,
place the CD player in a warm place
and leave the power on for about
one hour.
• Check all cable connections. (See
pages 10-12)
• Insert all plugs firmly into jacks.
• Set switch to proper position. See
your amplifiers operating instruc-
tions for more information.
• Clean the disc. (See page 19)
• Replace the disc.
• Place the CD player in a more stable
location.
• Clean the disc. (See page 19)
• Replace the disc.
• Load a disc into the tray.
• Use only the track numbers on the
disc.
• Turn off the TV, or move the unit
farther from the TV.
• Replace the batteries.
• Remote controller is possible within
a distance of approximately 5
meters from the unit’s sensor and a
detection range of 30°.
• Operate from a different position or
remove the obstacle.
• Connect the system components
properly according to the A-905X
instruction manual.
Cause
• Power cord plug is not properly
connected to AC outlet.
• Disc is in the disc tray upside down.
• Disc is dirty.
• Moisture has accumulated inside
the CD player.
• Incomplete or incorrect connec-
tions.
• Improper input selector switch set-
ting on amplifier.
• Disc is dirty.
• Disc is scratched.
• CD player has been bumped.
• Disc is dirty.
• Disc is scratched.
• No disc in the tray.
• A track number not on the disc is
being input.
• Interference from TV
• Battery level is low.
• Your position is too far from the
unit’s remote control sensor or out
of the sensor’s detection angle.
• An obstacle exists between you and
the unit’s remote control sensor.
• The system components are not
connected properly.
If you have any problems with the unit, please check the troubleshooting table below first.
For any problems not covered in the table, please consult your nearest Onkyo authorized service center.

Onkyo C-705X Specifications

Audio Specifications

sampling frequency	352.8 kHz
frequency response	5 Hz – 20 kHz
total harmonic distortion	0.005% (at 1 kHz)
dynamic range	96 dB
signal to noise ratio	90 dB
channel separation	85 dB (at 1 kHz)
output level	2 volts r.m.s.

Power

power consumption (230 V, 50 Hz model)	8 watts
power consumption (120 V, 60 Hz model)	9 watts
power supply rating (230 V, 50 Hz)	AC 230 V, 50 Hz
power supply rating (120 V, 60 Hz)	AC 120 V, 60 Hz

Weight and Dimensions

dimensions	205 x 91 x 275 mm
dimensions (inch)	8-1/16" x 3-9/16" x 10-3/16"
weight	2.2 kg, 4.9 lbs.