Onkyo CS-265 User Manual

En-29
Setting the Clock
1
Press the [TIMER] button repeatedly to
display “Clock.”
If the clock has not been set yet, only “Clock”
will appear.
2
Press the [ENTER] button.
3
Press the [q]/[w] buttons to set the day of
the week, then press the [ENTER] button.
4
Press the [q]/[w] buttons to set the hour,
then press the [ENTER] button.
To switch between 24-hour and 12-hour display,
press the [DISPLAY] button.
5
Press the [q]/[w] buttons to set the minute,
then press the [ENTER] button.
When you press the [ENTER] button, clock count
starts from 00 seconds.
Displaying the clock time
If the CD receiver is in standby mode, press the
[CLOCK CALL] button. The clock time appears on the
display for about 8 seconds. While the CD receiver is
turned on, press the [CLOCK CALL] button. The clock
time is displayed continuously.
Note:
• If a power outage occurs, the clock will stop and
“-- : --” will appear. Also, all programmed timers will
be canceled. Set the clock again, and turn on the
necessary timers.
Using the Timer
The CD receiver features a sleep timer that places the
unit into power standby mode after a specified period of
time. It also features four programmable timers that
initiate playback of a specified source at a specified
volume level at a specified time.
When the sleep timer is enabled, the CD receiver will
enter power standby mode after a specified period of
time.
1
While the power to the CD receiver is on,
press the [SLEEP] button.
“Sleep 90” appears for about 8 seconds, then the
unit will enter power standby mode in 90 minutes.
While the sleep timer is enabled, the SLEEP
indicator appears on the display.
2
While the Sleep time is displayed, press
the [SLEEP] button repeatedly to set the
desired time.
Each press of the [SLEEP] button will shorten the
sleep time in 10 minute increments.
Checking the Remaining Sleep Time
To check the remaining sleep time, press the [SLEEP]
button. You can shorten the sleep time in 10 minute
increments by pressing the [SLEEP] button while the
sleep time is displayed.
Canceling the Sleep Timer
To cancel the sleep timer, press the [SLEEP] button
repeatedly until “Sleep Off” appears. If you want to
power off the CD receiver immediately, press the [8]
button.
Before programming a timer, you must set the clock.
(see page 29) Also, if you plan to program a timer for
FM, first you must preset the desired FM broadcast
stations (see page 26).
1
Press the [TIMER] button repeatedly to
select a timer number (1–4).
If only “Clock” appears, the clock has not been
set yet. Set the clock first (see page 29).
2
Use the [q]/[w] buttons to select “On”,
then press the [ENTER] button.
This manual describes the procedure for using the
remote controller, unless otherwise specified.
Mon Tue Wed Thu Fri Sat Sun
This manual describes the procedure for using the
remote controller, unless otherwise specified.
Using the Sleep Timer
Programming a Timer

Onkyo CS-265 Specifications

General

Type	Home audio mini system
Cassette deck	No
Product color	White
Optical disc player	Yes
Karaoke	-
Impedance	6 Ω
Speaker type	2-way
Frequency range	30 - 22000 Hz
RMS rated power	40 W
Woofer diameter	100 mm
Tweeter diameter	20 mm
Number of speakers	2
Signal-to-Noise Ratio (SNR)	77 dB
Total Harmonic Distortion (THD)	0.1 %
FM band range	87.5 - 108 MHz
Supported radio bands	FM
Preset stations quantity	30
Display type	LCD
Bluetooth version	4.0
Power source	AC
Input voltage	220-240 V
Input frequency	50 - 60 Hz
Power consumption (standby)	0.4 W
Power consumption (typical)	32 W

Weight and Dimensions

Depth	176 mm
Width	130 mm
Height	210 mm
Weight	1700 g
Package depth	281 mm
Package width	357 mm
Package height	406 mm
Package weight	6700 g
Main unit weight	1900 g
Main unit dimensions (WxDxH)	215 x 273 x 99 mm