> Before Start > Part Names > Install > Playback
Advanced Setup | Others
25
En
Setting the alarm to start play
At the set time, the unit switches on and starts play of
the desired source. Make sure that the clock on this
unit is set correctly. You cannot use the timers if the
clock has not been set.
1. Press on the remote controller to display the
menu.
2. Press ENTER (c) when "Wakeup Timer" is
displayed.
3. Press 2/1 (b) to select "ONCE" or "DAILY" and
press ENTER (c).
4. Press 2/1 (b) to select "TIMER SET" and press
ENTER (c).
5. Press 2/1 (b) to select the source to use for timer
play, then press ENTER (c).
0 The sources you can select are "CD", "USB",
"DAB" (CS-375D) and "FM".
6. Press 2/1 (b) to select the day of the week, then
press ENTER (c).
0 If you select "DAILY", select one day of the week
to start and one to stop from amongst "SUN",
"MON", "TUE", "WED", "THU", "FRI", or "SAT"
and confirm.
7. Use 2/1 (b) to set the start time for the alarm, the
end time, and the volume (0 to 50) in turn, then
press ENTER (c) to confirm each selection.
0 lights on the display when the settings are
complete.
8. Press Í (a) to switch the unit to standby.
0 The alarm does not work when this unit is on.
Checking the alarm On/Off settings: If the alarm
setting is on, lights on the display when this unit is
on. When the unit is in standby mode, the TIMER
indicator lights red.
Turning the alarm setting On or Off: If the alarm is
already set, you can turn the function on or off.
1. Press on the remote controller to display the
menu, press ENTER (c) when "Wakeup Timer" is
displayed.
2. Press 2/1 (b) to select "ONCE" or "DAILY" and
press ENTER (c).
3. To turn off, press 2/1 (b) to select "TIMER OFF"
and press ENTER (c).
0 To turn on, press 2/1 (b) to select "TIMER ON"
and press ENTER (c).
4. Press Í (a) to switch the unit to standby.
1
2
b
a
c
To Next Page
Loading...
Need help?
General
Weight and Dimensions
