Onkyo DX-7333 User Manual

5
Before operating this unit
1. Remove the battery compartment cover by opening it as shown in
the illustration.
2. Insert two AA (R6- or UM-3)-size batteries into the battery compart-
ment. Carefully follow the polarity diagram (positive (+) and nega-
tive (–) symbols) inside the battery compartment.
3. After batteries are installed and seated correctly, replace the com-
partment cover.
Notes
•
Do not mix new batteries with old batteries or different kinds of
batteries.
•
To avoid corrosion, remove the batteries if the remote controller
is not to be used for a long time.
•
Remove dead batteries immediately to avoid damage from cor-
rosion. If the remote controller doesn’t operate smoothly,
replace both the batteries at the same time.
•
The life of the batteries supplied is about six months but this
will vary depending on usage.
Point the remote controller toward the remote control sensor.
Notes
• Place the unit away from strong light such as direct sunlight or
inverted fluorescent light which can prevent proper operation of the
remote controller.
•
Using another remote controller of the same type in the same
room or using the unit near equipment which uses infrared rays
may cause operational interference.
•
Do not put any object such as a book on the remote controller.
The buttons of the remote controller may be pressed by mistake
and drain the batteries.
• Make sure the audio rack doors do not have colored glass. Plac-
ing the unit behind such doors may prevent proper remote con-
troller operation.
•
If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.
Installing the remote controller batteries
Using the remote controller
3
2
1
Remote
control sensor
30˚
30˚
DX-7333
approx. 5 m
(16 feet)
R
EM
OTE
CO
NT
RO
LLE
R
R
C-4
02C
P
E
A
K
S
E
A
R
C
H
+10
0
T
I
M
E
E
D
I
T
C
L
E
AR
M
E
M
O
R
Y
R
E
P
E
A
T
D
I
S
P
L
A
Y
7
8
4
5
1
2
9
6
3
N
E
X
T
S
E
L
E
C
T
I
O
N
A
–B
S
H
U
F
F
L
E
DX-7333(E)BookPage52001年4月26日木曜日10:28AM

Onkyo DX-7333 Specifications

Audio Specifications

sampling frequency	352.8 kHz
frequency response	5 Hz - 20 kHz
total harmonic distortion	0.005% (at 1 kHz)
dynamic range	96 dB
signal-to-noise ratio	90 dB
channel separation	85 dB (at 1 kHz)
number of channels	2 (stereo)

Power

power consumption	9 watts
power supply	230-240 V, 50 Hz
output level	2 volts r.m.s.

Weight and Dimensions

weight	4.0 kg (8.8 lbs.)
dimensions	435 × 91 × 314 mm (17-1/8" × 3-9/16" × 12-3/8")