4 EN
3 Charge and
pair your
headset
Charge the battery
Note
• Before you use your headset for the first time,
charge the battery for 5 hours for optimum battery
capacity and lifetime.
• Use only the original USB charging cable to avoid
any damage.
• Finish your call before charging the headset, as
connecting the headset for charging will power the
headset o.
1 Plug one end of the USB cable into
the charger (or into the USB port of a
computer).
2 Plug the other end of the cable into the
micro USB charging slot on the headset.
» When the headset is charging,
a white indicator light will be
displayed.
» When the headset is fully charged,
the white light goes o.
Tip
• Normally, a full charge takes 2 hours.
Pair your headset
The headset stores the last 4 devices in
the memory. If you try to pair more than
4 devices, the earliest paired device is
replaced by the new one.
There are two ways to pair your headset
with your mobile phone:
• Manual pairing
• NFC pairing
Manual pairing
1 Make sure that the headset is fully
charged.
2 Make sure that the headset is o.
3 Press and hold the power on/o button
until the blue and white LED flashes
alternately.
4 Turn on the Bluetooth function of your
mobile phone.
» The headset is in pairing mode for
2 minutes.
5 Pair the headset with the mobile phone.
For detailed information, refer to the
user manual of your mobile phone.
NFC pairing
1 Make sure you turn on the NFC function
on your phone and your phone’s screen
remains active.
2 Place your phone over the headset so
that the NFC detection area of each
device can touch each other.
3 Pair the headset with the mobile phone.
For detailed information, refer to the
user manual of your mobile phone.
Note
• Make sure your mobile phone has the NFC feature
available and switched on.
• Make sure your mobile phone is not in standby
mode.
• Pairing with NFC is only suitable for Android mobile
operating system 4.2 or above.
• Refer to the user manual of your mobile phone to
identify its NFC detection area.
The following example shows you how to
pair the headset with your mobile phone.
1 Activate the Bluetooth feature of your
mobile phone, select Onkyo E300BT.
To Next Page
Loading...
Need help?
General
