Playback
En-46
You can adjust the brightness of the AV receiver’s
display.
When you connect an u-capable Onkyo
component, you must configure the input display so
that u can work properly.
This setting can be done only from the front panel.
You can temporarily mute the output of the AV
receiver.
Setting the Display Brightness
1
Press RECEIVER once followed by DIMMER
repeatedly to switch between: normal, dim, or
dimmer brightness.
Tip
• (North American and Taiwanese models)
Alternatively, you can use DIMMER on the AV
receiver.
Changing the Input Display
1
Press TV/CD or GAME.
“TV/CD” or “GAME” appears on the AV receiver’s
display.
2
Press and hold down the same button (about
3 seconds) to change the input display.
Repeat this step to select the desired input
display.
Note
“
•“DOCK” can be selected for the “TV/CD” or “GAME”
input selector, but not at the same time.
• Enter the appropriate remote control code before using
the remote controller for the first time (➔ page 72).
TV/CD → DOCK
→
→
TAPE
■ TV/CD:
GAME ↔ DOCK■ GAME:
Muting the AV Receiver
1
Press RECEIVER followed by MUTING.
The output is muted and the MUTING indicator
flashes on the AV receiver’s display.
Tip
• To unmute, press MUTING again or adjust the volume.
• Muting is automatically cancelled when the AV
receiver is set to standby.
To Next Page
Loading...
Need help?
General
