En-36
Advanced Operations
On-screen Setup
The setup menus provides a convenient way to change the
AV receiver’s various settings. Settings are organized into
10 categories.
Note
• The on-screen menus are displayed when:
– There is no video input, or
– The video input is 480p, 576p, 720p, 1080i, or 1080p.
Note
• This procedure can also be performed on the AV receiver by
using SETUP, the cursor buttons, and ENTER.
• During Audyssey 2EQ
®
Room Correction and Speaker Setup,
messages, etc., that are displayed on the TV screen will appear on
the AV receiver’s display.
Explanatory Notes
a Menu selection
b Setting target
c Setting options (default setting underlined)
The on-screen menus appear only on a TV that is
connected to the HDMI OUT. If your TV is connected
to other video outputs, use the AV receiver’s display
when changing settings.
This section describes the procedure for using the
remote controller unless otherwise specified.
Common Procedures in Setup Menu
1
Press RECEIVER followed by SETUP.
2
Use q/w to select a menu item, and then press
ENTER.
3
Use q/w to select a setting target, and use e/r to
change the setting.
Press SETUP to close the menu.
Press RETURN to return to the previous menu.
RETURN
SETUP
RECEIVER
ENTER
q/w/e/r
Remote indicator
Menu Sp Config
■ Subwoofer
` Yes
` No
a
b
c
Setup Menu
1. HDMI Input
2. Component
3. Digital Audio
4. Sp Config
5. Sp Distance
6. Level Cal
7. Audio Adjust
8. Source Setup
9. Hardware
10. HDMI Setup
BD/DVD
VCR/DVR
CBL/SAT
GAME
AUX
TV/CD
Menu
Setting target
To Next Page
Loading...
Need help?
General
