4
En
Controls
FRONT VIEW
a Standby/On indicator
Red: Subwoofer in standby mode
Blue: Subwoofer on
The Auto Standby function will automatically set the
SKW-770 to Standby mode when there is no input
signal, or when the input signal is below a certain
level.
Note
• If the Auto Standby function sets the SKW-770 to Standby mode
even when an input signal is present, the input signal level is too
low. In this case, increase the subwoofer output level on the
amplifier or AV receiver connected to the SKW-770.
REAR PANEL
b AC INLET
Connects the supplied power cord. From the two
supplied power cords, choose the one whose plug
matches the type of your AC wall outlet.
c OUTPUT LEVEL knob
Use this knob to adjust the volume of the subwoofer.
d LINE INPUT jack
Connect this jack to the SUBWOOFER PREOUT
jacks on the amplifier etc.
a
cbd
To Next Page
Loading...
Need help?
General
