6
En
Adjustments
To set the level of the subwoofer, use the
OUTPUT LEVEL knob. Set it so that bass
sounds are evenly balanced with the treble
sounds from the other speakers. Because our
ears are less sensitive to very low bass
sounds, there’s a temptation to set the level of the
subwoofer too high. As a rule of thumb, set the subwoofer
level to what you think is the optimal level, and then back
it off slightly.
Note
• Be careful not to allow the input of excessive power. Input levels
that greatly exceed normal situations can damage the SKW-770.
Also note that switching operations at the amplifier may
generate excessive noise that may result in damage. When using
switches at the amplifier, first lower the volume to prevent
accidental damage.
Placement
The placement of the SKW-770 can greatly affect the
sound that is produced. In general, a good bass sound can
be obtained by installing the subwoofer in a front corner,
or at one-third the width of the wall, as shown.
Corner
1/3 room
length
To Next Page
Loading...
Need help?
General
