120
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
Auto Standby On/O This setting allows the unit to enter standby mode
automatically after 20 minutes of inactivity without
any video or audio input. (When "USB Power Out
at Standby" or "Network Standby" is enabled, the
unit enters the HYBRID STANDBY mode which
minimizes the increase in power consumption.)
"On": The unit automatically enters standby mode
("AUTO STBY" lights up).
"O": The unit does not automatically enter standby
mode.
• "Auto Standby" is displayed on the main unit’s
display and TV screen 30 seconds before
entering standby mode.
• "Auto Standby" does not work when Zone 2 is
active.
• Default values vary depending on the regions.
Auto Standby in
HDMI Standby
Through
O Enable or disable "Auto Standby" while "HDMI
Standby Through" is on.
"On": The setting is enabled.
"O": The setting is disabled.
• This setting cannot be set to "On" if "Auto
Standby" and "HDMI Standby Through" are set
to "O".
USB Power Out
at Standby
O When this function is set to "On", electricity can be
supplied to the device connected to the USB port
even if this unit is in standby mode .
• When this function is set to "On", the power
consumption in standby state increases,
however, the increase in power consumption is
minimized by automatically entering the HYBRID
STANDBY mode where only the essential circuits
operate.
Setting Item Default Value Setting Details
Network Standby On
When this function is set to "On", the network
function works even in standby state, and you can
turn on the power of the unit via network using
an application such as Onkyo Controller that can
control this unit.
• When this function is set to "On", the power
consumption in standby state increases,
however, the increase in power consumption is
minimized by automatically entering the HYBRID
STANDBY mode where only the essential circuits
operate. Note that even if this function is set to
"O", when any of the HDMI CEC (
p116),
HDMI Standby Through (
p116), USB Power
Out at Standby (
p120) and Bluetooth
Wakeup ( p120) functions is enabled, this
function will be in “On” state regardless of the
setting.
• When connection to the network is lost, "Network
Standby" may be disabled to reduce power
consumption. In such a case, turn the unit on by
using the power button on the remote controller
or main unit.
Bluetooth Wakeup O
This function wakes up the unit on standby by
connecting a BLUETOOTH-enabled device.
"On": When this function is used
"O": When this function is not used
• When this function is set to "On", the power
consumption in standby state increases,
however, the increase in power consumption
is minimized by automatically entering the
HYBRID STANDBY mode where only the
essential circuits operate.
• This setting is xed to "O" if "Bluetooth" - "Auto
Input Change" is set to "O".
• Wait for a while if "Network Standby" and "Bluetooth Wakeup" cannot be selected. It can
be selected when the network function is activated.
To Next Page
Loading...
Need help?
General
