Onkyo TX-SR309 User Manual

16
En
This section explains how to connect the supplied indoor FM antenna and AM loop antenna.
The AV receiver won’t pick up any radio signals without any antenna connected, so you must connect the antenna to use
the tuner.
Note
• Once your AV receiver is ready for use, you’ll need to tune into a radio station and position the antenna to achieve the best possible
reception.
• Keep the AM loop antenna as far away as possible from your AV receiver, TV, speaker cables, and power cords.
Tip
• If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available outdoor FM antenna instead.
• If you cannot achieve good reception with the supplied indoor AM loop antenna, try using it with a commercially available outdoor
AM antenna.
Note
• Before connecting the power cord, connect all of your
speakers and AV components.
• Turning on the AV receiver may cause a momentary power
surge that might interfere with other electrical equipment on the
same circuit. If this is a problem, plug the AV receiver into a
different branch circuit.
• Do not use a power cord other than the one supplied with the AV
receiver. The supplied power cord is designed exclusively for
use with the AV receiver and should not be used with any other
equipment.
• Never disconnect the power cord from the AV receiver while the
other end is still plugged into a wall outlet. Doing so may cause
an electric shock. Always disconnect the power cord from the
wall outlet first, and then the AV receiver.
Connecting Antenna
Connecting the Power Cord
Thumbtacks, etc.
Insert the plug fully
into the jack.
Insert the plug fully
into the jack.
North American and
Taiwan models
European, Australian
and Asian models
Push. Insert wire. Release.
Assembling the AM loop
antenna
Indoor FM antenna (supplied)AM loop antenna (supplied)
Caution
• Be careful that you don’t injure yourself when
using thumbtacks.
1
(Taiwan models)
Connect the supplied power cord to the AV
receiver’s AC INLET.
2
Plug the power cord into an AC wall outlet.
To AC wall outlet

Onkyo TX-SR309 Specifications

General

Impedance	16 Ω
Receiver type	-
Frequency range	20 - 50000 Hz
Output impedance	2200 Ω
Input sensitivity	200 mV
Audio output channels	5.1 channels
Signal-to-Noise Ratio (SNR)	100 dB
Total Harmonic Distortion (THD)	0.08 %
Dynamic power per channel (3 Ohm)	160 W
Dynamic power per channel (4 Ohm)	125 W
Dynamic power per channel (8 Ohm)	85 W
Power output per channel (20-20KHz@8 Ohm)	100 W
HDMI in	3
Audio (L/R) in	6
Composite video in	1
Component video (YPbPr/YCbCr) in	2
Connectivity technology	Wired
Speakers connectivity type	Binding post
Audio formats supported	AAC, FLAC, MP3, WMA
Ethernet LAN	No
RDS features	PS, PTY, RT, TP
AM band range	522 - 1611 kHz
FM band range	87.5 - 108 MHz
Supported radio bands	AM, FM
Radio Data System (RDS)	Yes
Preset stations quantity	40
Supported video modes	1080i, 720p
Product color	Silver
Audio decoders	Dolby TrueHD, DTS-HD
Volume control	Rotary
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (typical)	300 W
Certification	CE, EMC
Package weight	10500 g
Package depth	416 mm
Package width	537 mm
Package height	268 mm

Weight and Dimensions

Depth	328 mm
Width	435 mm
Height	150 mm
Weight	7500 g