EasyManuals Logo
Home>Onyx>Engine>LX700

Onyx LX700 User Manual

Onyx LX700
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
17
TROUBLESHOOTING
Hard starting
No fuel
Stale fuel or build-ups in tank
Incorrect starting procedure
Spark plug disconnected
Check and refuel
Empty fuel tank and rell with fresh fuel
Perform the starting procedure correctly
Problem Reason Solution
Dirty electrodes or incorrect gap
The spark plug cap is inserted incorrectly
Air lter clogged
Throttle trigger in “CHOKE” position
Fault in carburation
Fault in ignition
Check
Check that the cap is tted correctly
Check and Clean
Move the lever to the “FAST” position
Contact a Licensed Service Center
Contact a Licensed Service Center
Inconsistent
working
Check that the spark plug cap ts
well over the plug terminals
The spark plug is wet or the spark plug electrodes are
dirty or placed inadequately
Check
Air lter clogged
Incorrect oil for the season
Check and clean
Replace with proper oil
Fuel evaporation in the carburetor
(vapor lock) due to high temperatures
Wait for a few minutes then start
again
Fault in carburation
Hard starting
Contact a Licensed Service Center
Contact a Licensed Service Center
Air lter clogged
Fault in carburation
Governor out of phase with respect to the accelerator
Check and clean
Contact a Licensed Service Center
Adjust the cable
Loss of power
whilst operating
REFILLLING AND OPERATION MATERIALS:
Fuel
Engine Oil: From 5° to 35° C
From -25° to 5° C
From -7° to 35° C
Oil Capacity
Spark Plug
Spark Plug gap
Propane
SAE 30
5W-20 or 5W30
Synthetic 10W-30 or 15W-40
2.0 Liter
F7TRC (NHSP) or equivalent
0.6-0.8mm

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onyx LX700 and is the answer not in the manual?

Onyx LX700 Specifications

General IconGeneral
BrandOnyx
ModelLX700
CategoryEngine
LanguageEnglish