DEBINDING WITH METALBIND
1. Lift the binding handle (1) up to the open position.
2. If fitted remove adjustable stop (11).
3. Ensure the clamp lever(2) is completely to the left, till it is locked in position.
4. Put the bound document flat on the equipment face down, back cover up.
5. Push the bound document, channel against the back support,firmly.
6. Open the bound document 5 to 6 pages from the back cover.
7. For de-binding channels 1.5 and 3mm, use the de-binding adapter (6)
Place the de-binding adapter (6) on the channel, small slot is for 1.5 mm, bigger slot
for 3 mm.
7
CBIND SYSTEM
Accessories for binding, measuring, de-binding covers of the C-Bind system.
• Channel width selecting tool (7)
• O.CB Pivot Inserts for Atlas 190 for binding C-Bind covers, two part kit for all covers (dig.1)
• O.CB Debinding tool for Atlas 190 - de-binding wedge (dig.2) and AA cover de-binding jig
tool (dig.3)
8
6
back
cover
1
8. Fit the right end of the wedge (5) blade edge towards the
channel, in the right hook (4) then place the left end of
the wedge into the left hook (4).
9. Push the handle (1) down and up until the document is
de-bound. The wedge slips into documents and open the
channel.
10. Pull the handle (1) to the open position and move the
clamping lever (2) to the left till it is locked.
11. Remove covers and pages together with the wedge, then
take the wedge out of the document carefully.
12. Make the planned changes to the document and re-bind. The cover may be re-used
(a maximum of three times).
De-binding wedge (5) and the COVER guide (8) should be stored in the
slot at the side of the equipment. The storage method is shown in the
drawing. Notice! When inserting elements into the slot, make sure that
the handle (1) is in the upper position and the clamp lever (2) is on the
left side.
8
5
De-binding
To Next Page
Loading...
Need help?
General