Setting SP Policy for Host Power at Boot (Oracle ILOM)
■ To gracefully shut down the server, type stop /System.
■ To immediately shut down the server, type stop -f /System.
■ To power on the server, type start /System.
3.
If you are prompted to confirm your choice, type y, and then press Enter.
Related Information
■
Controlling Host Power, Oracle ILOM Administrator's Guide for Configuration and
Maintenance, Firmware Release 4.0.x
Setting SP Policy for Host Power at Boot (Oracle ILOM)
By default, when AC power is applied to the server, the server enters Standby power mode.
However, it is possible to change this default power state by configuring a power-on policy in
Oracle ILOM.
Set SP Host Power Policy at Boot
Before You Begin
Before you perform the following procedure, ensure that you have Admin (a) role privileges in
Oracle ILOM.
1.
To set a power-on policy in the Oracle ILOM web interface, perform the following
steps:
a.
Log in to the Oracle ILOM web interface.
For instructions, see “Accessing Oracle ILOM” on page 21.
b.
In the navigation pane, click System Management → Policy.
c.
In the Service Processor Policies table, select one of the following policies:
■ Auto power-on host on boot
Controlling the Server Power State 45
To Next Page
Need help?
General
