Push Buttons
These push buttons on the timer are used for programming and
other operations:
A Home/ Lock
Used to exit settings; to go into AUTO MODE, or to lock the
touch screen.
b System Off A single push will open the Rain Delay screen.
A second push of the button will place the entire system in
OFF mode.
c Reset (pin hole)
Resets the timer to its factory settings.
d RF Sync (only on remote control model)
Allows the timer to synchronize with a new remote or wire
less sensor.
e Rain Sensor
In Active position the controller will monitor the rain sensor,
in Bypass position the controller will ignore the rain sensor.
(This switch is for hard wired sensors only and does not
effect wireless rain sensors).
Section 2: Getting Started
Set Language
• Press the RESET button. The controller will now take you
through a step by step programming process.
• Press or on the touch screen to set the language of your
choice (English, Spanish, French, German or Italian).
• Press ENTER.
Set Current Time and Date
• Press or to set the current time. Press ENTER.
• Press or to set the current year. Press ENTER.
• Press or to set the current month. Press ENTER.
• Press or to set the current day of the month.
Press ENTER.
Determine a Watering Plan
See page 14 for instructions.
To Next Page
Loading...
Need help?
General