13
Workout in WATT constant mode:
In standby mode, select WATT and press MODE to enter.
The preset watt value 120 is flashing on screen in WATT setting mode, select UP/DOWN/ENTER to set
target value from 10 to 350. Pressing START button to start training.
After start, Level is adjusted according to RPM to reach the setting WATT.
▲ ：WATT ＞ setting WATT 25% – user need to slow down
● ：WATT = setting 25%
▼ ：WATT ＜ setting 25% – user need to speed up
---： WATT ＞ or ＜ setting WATT 50% (OVER SPEC)---
BODY FAT
You may test and have the BODY FAT advice when the computer is in STOP mode. Please follow the
steps as below:
1. Press BODY FAT button, and hold on handgrip to start body fat testing.
2. The symbol "- - - - - - - - " will display while testing period in 8 seconds. After 8 seconds, you will
see the BODY FAT advice in percentage and BMI and the fat advice in different symbol.
3. It would be possible to display other indication if you have the following situation:
"E-1" - When you see this indication, it means you did not put your thumb properly on the
conductor. Please try again.
To Next Page
Loading...
Need help?
General
