Oreck magnesium User Manual

Cord Clip
1
2 3
8
9
10
4
Assembling the Handle
1. Align the four connector tabs at the bottom of the Magnesium
™
handle with the four receiving ports at the top of the outer
bag and insert until a “snap” is heard.
2. Snap cord assembly into the cord clip located on the back of
the Magnesium
™
handle. Leave excess cord at the power
head to allow movement.
3.
Remove the protector (Mylar Tab) sheet for the Magnesium
™
RS and RF.
Make sure the disposable inner bag is in place. Do not operate
the vacuum without a disposable inner bag. Plug the power
cord into an electrical outlet and press the ON/OFF switch on
the back of the vacuum when ready to operate. Press the
button once to turn the unit on high, press a second time for
low speed, and a third time to turn the unit off.
4.
Up-Position Lock - Place foot on power head and lean handle
back gently to release lock for vacuum use. Return handle to
the full upright position to engage lock. NOTE: Do not operate
the vacuum while in the upright and locked position. Do not
let the vacuum run while in any one stationary position for
any period of time. Keep the vacuum moving while in operation.
5.
Cord Release - To remove cord, twist cord release 1/2 turn. Slide
cord off cord release.
6.
Easy Power Cord Storage - Turn cord release to the up
position, wrap power cord around cord release and lower cord
bracket located below the carry handle.
7.
Carry Handle - The carry handle is located on back of the
vacuum for easy lifting and carrying.
Make sure the disposable inner bag is in place.
Do not operate the vacuum without a disposable
inner bag. Plug the power cord into an electrical
outlet. Press the ON/OFF switch (top) on the
handle and the unit turns ON in high speed. Press
the Low Switch (bottom) to change to low speed
operation. Press the High Switch (middle) to return to high speed
operation. Press ON/OFF switch (top) again to turn the unit off.
4.
Up-Position Lock - Place foot on power head and lean handle
back gently to release lock for vacuum use. Return handle to
the full upright position to engage lock. NOTE: Do not operate
the vacuum while in the upright and locked position. Do not
let the vacuum run while in any one stationary position for
any period of time. Keep the vacuum moving while in operation.
5. Cord Release - To remove cord, twist cord release 1/2 turn. Slide
cord off cord release.
OPERATION
Operating the Oreck Magnesium
™
& Magnesium
™
SW
Operating the Oreck Magnesium
™
RF & RS
3

Oreck magnesium Specifications

General

Brand	Oreck
Model	magnesium
Category	Vacuum Cleaner
Language	English