10
9. Turn the Seal Selector (Figure 7) on the Jar Lid to the rest selection ( ) to
take the Jar Lid off the Blending Jar.
Note: Pushing down on the Seal Selector or turning the Seal Selector away from the
vacuum selection ( ) introduces air to your drink/meal.
Using the Manual Modes
WARNING: Do not overfill the Blending Jar past the MAX fill line. Overfilling
may create a hazard and damage the blender.
1. (Optional) To vacuum blend, press the Vac + Blend (Auto) Button.
2. Turn the Seal Selector (Figure 7) on the Jar Lid to the appropriate selection:
( ) Blending Only
( ) Vacuum Blending
3. Press one of the below buttons to select a manual mode.
Low
Med
High
4. When ready to begin, press the Start/Stop button.
5. Press the Start/Stop button to stop blending and press the Power button
to turn the blender off. This appliance is pre-programmed to turn off
automatically if not used for a period of several minutes. All lights will turn
off when the unit automatically powers down.
6. Press the Arm Release Button to lift the Arm Lock up on the FoodSaver™
Vacuum Arm (Figure 2).
7. Holding the handle, turn the Blending Jar counter-clockwise and then lift the
Blending Jar up and way from the Motor Base.
8. Push the Arm Lock on the FoodSaver™ Vacuum Arm down (Figure 6).
9. Push down on the Seal Selector to release the vacuum seal.
10. Turn the Seal Selector (Figure 7) on the Jar Lid to the rest selection ( ) to
take the Jar Lid off the Blending Jar.
Note: Pushing down on the Seal Selector or turning the Seal Selector away from the
vacuum selection ( ) introduces air to your drink/meal.
Caring for Your Product
Cleaning
WARNING: Blades are sharp. Handle carefully.
Empty the Blending Jar. If necessary, use a rubber spatula to scrape foods away
from the sides of the jar. CAREFULLY remove the Blade Assembly from the
Blending Jar by holding the jar upright and turning the Blade Assembly counter-
clockwise. All parts (except for the FoodSaver™ Vacuum Arm and the Motor
Base) are dishwasher safe. Use the top rack of the dishwasher for the Jar Lid, Seal
Selector, Cup Lid, Cup, Sealing Ring and Blade Assembly. Place the Blending Jar
into the bottom basket of dishwasher.
The Blending Jar, Jar Lid, Seal Selector, Cup Lid, Cup, Sealing Ring and Blade
Assembly can also be hand washed with warm, soapy water. Rinse well and dry.
It is recommended to hand wash the Blade Assembly for longer usage.
If necessary, the Seal Selector can be disassembled for a more thorough clean.
To disassemble, hold the Seal Selector with the seal selector top facing upwards
and turn the screw cap counterclockwise. All parts of the Seal Selector should
be hand washed with warm, soapy water. To reassemble, hold the Seal Selector
with the seal selector top facing upwards. With the spring (the silicone cap facing
BLSTAB-CB0_19ESM2 (US).indd 10 5/24/19 9:46 AM
To Next Page
Loading...
Need help?
General