13
Using Your Vacuum Storage Cup Accessory
Before you use the product for the first time, separate all parts and clean them.
Refer to Page 10-11 for cleaning instructions - the Cup and Cup Lid are top rack
dishwasher safe.
Note: You cannot blend in the Vacuum Storage Cup.
1. Pour your blended drink or meal into the Cup.
2. Secure the Cup Lid onto the Cup by aligning the notch in the Cup to the tab on
the Cup Lid.
3. Press the Arm Release Button to lift the Arm Lock on the FoodSaver™ Vacuum
Arm (Figure 2).
4. Place the Vacuum Storage Cup on the Motor Base so that the Cup Lid’s vacuum
port (Figure 8) aligns with the FoodSaver™ Vacuum Arm’s vacuum port (Figure
4a).
5. Plug the power cord into a standard household 120/127 volt, 60 hz. AC outlet.
6. Press the Power Button to turn the blender on, the FoodSaver™ Vacuum Arm
Light Indicator will blink three times and then stay on.
7. Push the Arm Lock on the FoodSaver™ Vacuum Arm down (Figure 6). The
FoodSaver™ Vacuum Arm Light Indicator will turn off.
8. Press the Vacuum (Storage) button.
9. When ready to begin, press the Start/Stop button. The blender will stop
automatically when vacuuming is complete. Press the Start/Stop button to cancel
the program at any time.
10. Press the Power button to turn the blender off. This appliance is pre-programmed
to turn off automatically if not used for a period of several minutes. All lights will
turn off when the unit automatically powers down.
11. Press the Arm Release Button to lift the Arm Lock up on the FoodSaver™
Vacuum Arm (Figure 2).
12. Lift the Vacuum Storage Cup up and away from the Motor Base.
13. Push the Arm Lock on the FoodSaver™ Vacuum Arm down (Figure 6).
14. To drink from the Vacuum Storage Cup, press the Vacuum Release Button on the
Cup Lid.
Note: Pressing the Vacuum Release Button introduces air to your drink/meal.
Figure 8
Figure 9
BLSTAB-CB0_19ESM2 (US).indd 13 5/24/19 9:46 AM
To Next Page
Loading...
Need help?
General