OWIM HG00073B User Manual

16 GB/CY
Mounting the temperature station
and / or the outdoor sensor on a wall:
Note: You will require an electric drill and a
crosshead screwdriver for this step.
CAUTION! DANGER TO LIFE, RISK
OF INJURY AND MATERIAL DAMAGE!
Read the operating and safety instructions for
your drill carefully.
DANGER TO LIFE!
Take care that you do not hit electricity, gas
or water lines when you drill into the wall. If
necessary, check with a pipe and cable de-
tector before drilling.
Temperature station
Mark the position of the hole (ø approx.
7.7 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
27
into the drilled hole.
Using a crosshead screwdriver, screw the
screw
26
into the dowel.
Hang the temperature station by placing
the hanger
23
on the screw.
External sensor
Mark the position of the hole (ø approx.
7.7 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
32
into the drilled hole.
Using a crosshead screwdriver, screw the
screw
31
into the dowel.

OWIM HG00073B Specifications

General

Brand	OWIM
Model	HG00073B
Category	Temperature Controller
Language	English