21 GB
switch
29
on the outdoor sensor. The relevant data is
shown in the LC-display.
- 1: Outdoor sensor on channel 1
- 2: Outdoor sensor on channel 2
- 3: Outdoor sensor on channel 3
-
: automatic channel change
Low battery:
If the battery symbol appears the batteries in the outdoor
sensor should be replaced as soon as possible. Please
refer to the instructions in section Starting the outdoor sensor /
changing batteries.
Settings
ATTENTION: Firmly touching the top of the housing will turn on the
backlight (Fig. E). 10 seconds after releasing it the display backlight
will turn off again. In the battery or mains operation, have three
brightness level can be selected.
Please note, the main station does not respond to two buttons being
pressed at once. Hence, if the unit does not respond to a button being
pressed, you are probably also pressing the SNOOZE / LIGHT field.
Release when this occurs!
Basic settings
Press and hold the SET- / HISTORY button
7
for 3 seconds to
change the basic settings.
Pressing the UP button
8
or the DOWN- / button
9
allows
you to now change the respective flashing value.
To Next Page
Loading...
Need help?
General
