will also change to show the air conditioner No.) /
Press the TIMER SELECT/SET button while the error is displayed. /
The F15 - F49 display will change to the detail display. /
- After checking the error display and the detail display, refer to the
self-diagnosis error code table on the following page and check
the location of the problem.
- If the problem is repaired and operation returns to normal, the
CHECK display on the remote control will be eliminated, but the
self-diagnosis LED will remain illuminated until the operation
starts again.
How to display the past error message /
If the “CHECK” display on the wired remote control is not flashing, press the CHECK button
continuously for 5 seconds or more to display the problem details for the last problem or the
problem before that. You can then switch between the displays for the previous problem and
the problem before that by pressing the TIMER FORWARD or BACK buttons. / (Last problem
display: 1F15 - 1F49 / Second-last problem display: 2F15 - 2F49) / / Press the CHECK button
once more to return to the normal display. /
/ An error code from 1F15 to 1F49 will be displayed. / (The temperature setting display will also
change to show the air conditioner No.) /
/ If the TIMER SELECT/SET button is pressed while the error code from 1F15 to 1F49 is being
displayed, the display screen will change to show the details of the last problem display. / (If
2F15 to 2F49 is being displayed, the details of the second-last problem display will appear.)
119
To Next Page
Loading...
Need help?
General
