Panasonic DMC-FP8S - Lumix Digital Camera User Manual

- 151 -
Others
[READ ERROR/WRITE ERROR
PLEASE CHECK THE CARD]
•
It has failed to read or write data.
> Remove the card after turning the power [OFF]. Insert the card again, turn the power on,
and try to read or write the data again.
• The card may be broken.
> Insert a different card.
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
•
When you set the picture quality to [ ], [ ] or [ ], we recommend using a high-speed
card with “10MB/s” or greater displayed on the package.
• In the event that it stops even after using a “10MB/s” card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P29).
• Depending on the type of SD Memory Card or SDHC Memory Card, motion picture recording
may stop in the middle.
[A FOLDER CANNOT BE CREATED]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
(P130)
> Format the card after saving necessary data on a PC etc. (P29) If you execute
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P27)
[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]
•
The AV cable is connected to the camera.
> Press [MENU/SET] if you want to delete this message at once.
> Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P28)
• This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P128,
131)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
•
The printer cannot print.
> Check the printer.
[NO BATTERY POWER REMAINS]
•
The remaining battery power is low.
> Charge the battery.
[THIS BATTERY CANNOT BE USED]
•
The battery cannot be recognized by the camera.
> Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service center.
• The battery cannot be recognized as its terminal is dirty.
> Remove any dirt etc. from the terminal.

Panasonic DMC-FP8S - Lumix Digital Camera Specifications

General

Brand	Panasonic
Model	DMC-FP8S - Lumix Digital Camera
Category	Digital Camera
Language	English