EN11
Setup
Check the main unit and accessories
Main Unit
Accessories
z
Lock switch key (1)
z
Comfort cushion
z
Power cord
1
)
Open the packing box and take out the the
massage lounger and accessories
2
)Set up the massage lounger
z
Since this unit is heavy, please be careful not to
hurt your back etc when moving in.
(The unit to be
carried by two or more people.)
Unit weight: approx. 69 k
g
z
When lowering the main unit please pay attention to
your feet and slowly lower it.
z
Do not release the leg/foot massage section until
the unit is safely placed at.
Suddenly loosening your hand will cause the leg/
foot massage section to bounce back to the original
position.
When lifting it up to carry in and install it
If you do not hold it properly, it will cause the body to
fall and damage the floor.
Please fully recline the backrest and lift the main unit
again with the legrest put back.
Installed on the main unit when delivered.
Status of removal from the packing box.
(When the backrest is fully down)
Close the zipper on
the upper part of the
backrest.
How to attach the
Comfort cushion:
Hold it by the hard
part inside.
Installation
place
( lay a mat etc.)
Open the hook and put your
hand into the groove.
Close the surface fastener after
setting.
Place the controller in
the controller pocket and
place the power cord on
the seat surface.
Do not
hold here
Parts and functions / Setup
To Next Page
Loading...
Need help?
General