11
English
Lubrication
•Apply the oil to the clipper before and after each use.
Apply a drop of the oil to each
indicated point.
Failure to apply the oil may cause the
following problems due to rust, wear or
burn out.
-The clipper has become blunt.
-Shorter operating time.
-Louder sound.
Cleaning the charging stand
Use the cleaning brush to clean hair trimmings and dust in the
charging plug or in the hole on the bottom surface.
Troubleshooting
Problem Action
The clipper has become
blunt.
Charge the clipper.
(See page 8.)
Clean the blade and apply oil.
(See pages 10 and 11.)
Replace the blade.
(See page 10.)
Clipper stopped functioning.
Charge the clipper.
Or use with the AC operation.
(See page 8.)
The clipper cannot be
charged.
Push the main body into the
charging stand or appliance
plug all the way.
Charge within the
recommended charging
temperature of 10 °C to 35 °C.
Clipper can be used for only
about 10 minutes even after
charging.
Have the battery replaced by an
authorized service center.
Makes a loud sound.
Confirm that the blade is
properly attached.
If the problems still cannot be solved, contact the store where you
purchased the unit or a service center authorised by Panasonic for
repair.
ER-GP80_ME.indb 11 2014/03/25 14:23:45
To Next Page
Loading...
Need help?
General
