:
Programming using the Base Unit (KX-TGP550 only)
38
Document Version 2012-01
3 {EXIT}
Viewing/editing/erasing call block
numbers
1
{MENU} (middle soft key) i {# }{2}{1}{7}
2 {V}/{^}: Select the desired entry.
L To exit, press {EXIT}.
3 Proceed with the desired operation.
■ Editing a number:
{MENU} i {V}/{^}: “Edit” i
{SELECT} i Edit the phone number. i
{SAVE} i {EXIT}
■ Erasing a number:
{MENU} i {V}/{^}: “Erase” i
{SELECT} i {V}/{^}: “Yes” i
{SELECT} i {EXIT}
Note:
L When editing, press the desired dial key to add,
{CLEAR} to erase.
Anonymous calls (Block
Caller ID)
This feature allows the unit to make a call
anonymously.
The default setting is “Off”.
Important:
L We recommend setting this feature with your
administrator. Contact your administrator for
further information.
1 {MENU} (middle soft key)
2 {V}/{^}: “IP service” i {SELECT}
3 {V}/{^}: “Call features” i {SELECT}
4 {V}/{^}: “Block Caller ID” i
{SELECT}
5 Proceed with the desired operation.
■ When 1 line is registered:
Go to step 6.
■ When 2 or more lines are registered:
{V}/{^}: Select the desired line. i
{SELECT}
6 {V}/{^}: Select “On” or “Off”. i {SAVE}
i {EXIT}
Date and time
Set if the unit does not show the date and time. You
can set the date and time through the Web user
interface and also program it to adjust
automatically using the SNTP. Also, daylight
saving time setting is available through the Web
user interface. Contact your administrator for
further information.
1 {MENU} (middle soft key) i {#}{1}{0}{1}
2 Enter the current month, date, and year.
Example: March 15, 2010
{0}{3} {1}{5} {1}{0}
3 Enter the current hour and minute (12-hour
clock format).
Example: 9:30
{0}{9} {3}{0}
4 {AM/PM}: Select “AM” or “PM”.
5 {SAVE} i {EXIT}
Note:
L When English is selected as the display
language, 12-hour clock format is used. When
Spanish or French is selected, 24-hour clock
format is used.
L To correct a digit, press {3}, {4}, {^}, or {V} to
move the cursor to the digit, then make the
correction.
Updating the base unit
software
Your phone system dealer may offer new features
and improve its software version from time to time.
If you set the base unit software update setting to
manual mode through the Web user interface, you
need to download the update when “Update
version.Press OK.” is displayed. Contact your
administrator for further information.
Important:
L Make sure the STATUS indicator on the base
unit is lit in green and no line is in use (page 8).
1 Press {OKL} while “Update
version.Press OK.” is displayed.
L The current and new base unit software
versions are displayed.
To Next Page
Loading...
Need help?
General
