- 67 - VQT3T39
Q&A Troubleshooting
Recording (Continued)
Recorded pictures appear coarse, or there is interference.
●
ISO Sensitivity is high, or shutter speed is low.
(Default [Sensitivity] setting is [AUTO] – interference may appear with indoor pictures.)
→ Lower [Sensitivity] (→43).
→ Take pictures in brighter locations.
●
Camera is set to [High Sens.].
(Picture becomes slightly coarser in response to high sensitivity.)
Brightness or colouring of recorded picture different from real life.
●
When recording under fluorescent or LED lighting fixture etc., increasing the shutter
speed may introduce slight changes to brightness and colour. These are a result of the
characteristics of the light source and do not indicate a malfunction.
Red banding may appear on the LCD monitor or part or the entire
screen may have a reddish tint, when recording or pressing the
shutter button halfway.
●
This is a characteristic of CCD and may appear if subject contains
brighter areas. Some blurring may occur around these areas, but this
is not a fault. This will be recorded in motion pictures, but not in still
pictures.
●
We recommend keeping the screen away from strong light sources
such as sunlight when taking pictures.
Motion picture recording stops midway.
●
With some cards, access display may appear briefly after recording, and recording may
end midway.
●
When recording motion picture, use a card rated with an SD speed class
∗
of “Class 6”
or higher.
∗
SD speed class refers to a specification for sustained write speeds.
●
If recording stops even when using a card with speed of “Class 6” or faster, the data
writing speed is low. We recommend backing up the data on the memory card and
reformatting it. (→28)
The beep volume is low.
●
The speaker is blocked.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
