VQT2M30 (ENG)
14
• Use the camera underwater up to 10 m (33 feet) depth, water temperature from
0 oC to 40 oC (32 oF to 104 oF), and not longer than 60 minutes continuously.
• If there is water or dirt on the camera, use it after wiping it off with a dry soft cloth
and have it dry out in a well ventilated area.
• Do not open or close the card/battery door or terminal cover.
• Do not apply shock to the camera underwater. (Waterproof performance may not
be maintained, and there is a chance of water leak.)
• Do not dive into the water holding the camera. Do not use the camera at a
location where water will splash strongly, such as rapid flow or a waterfall.
(Strong water pressure may be applied, and it may cause malfunction.)
• The camera will sink in the water. Take care not to drop the camera and lose it
underwater by securely placing the hand strap around your wrist or similar
measure.
• Do not use it in hot water over 40 oC (104 oF) (in the bath or hot spring).
• When the camera is splashed with detergent, soap, hot spring, bath additive,
sun oil, sun screen, chemical, etc., wipe it off immediately.
• Card and battery are not waterproof. Do not handle with a wet hand. Also, do not
insert wet card or battery into the camera.
Using the camera underwater
DMC-FT2&TS2P-VQT2M30_eng.book 14 ページ ２０１０年１月２９日 金曜日 午後５時３１分
To Next Page
Loading...
Need help?
General
