Maintenance and Care
Maintenance and Care
Maintenance and Care Maintenance and Care
Door Glasses and Door Gaskets
Pump Filter
1.Remove the power plug of the washing
machine,press the two clasps as shown
in the picture, pull out the right clasp first,
then pull out the left clasp and take the
service board out.
Warning
Machine Body
- Never spray water into the machine body.
- Never use abstergent, thinner or products
containing alcohol or kerosene.
Detergent Container
2.Remove the detergent container by
pulling it out while pressing down on
the middle of the softener cover.
3.Remove the softener cover.
4.Wash out the detergent residue with
water. Use a cloth to wipe the water
from the washing machine.
5.Attach the softener cover to the
original position of the softener box.
1.Pull out the detergent container
22 23
Softener cover
Press down the middle of
the softener cover
Draw out
1
2
The machine body should be cleaned
using a soft cloth and moderate detergent,
for example, kitchen detergent and soap
water.
Make sure that the detergent container is
periodically cleaned to prevent residual
detergent and generation of bacteria.
Do the following whenever the work
of the machine is finished.
-Remove any objects on the door gasket.
-Wipe the door glass and door gasket with
a dry soft cloth to remove any wire debris
and dirt
-Open the door for ventilation and drying
if required.
2.After placing the saucer under the filter, open
the pump filter by rotating the filter to the left
to discharge the residual water.
3.Clean the residue and dirt & stains on
the pump filter. Confirm if the pump
behind the filter is blocked.
4.Re-assemble the filter and the service
panel after cleanup. Check for water
leaks.
Remove softener
cover hook
(2 places)
Pull in the direction
of the arrow
2
1