No
washing
Abnormal
draining
Abnormal
spin
Identify usual trouble of washing machine
List of faults and inspection
Faults
Inspection Items
No water
flows in
If the power is off or the fuse is burned out.
If the water supply is cut off or the water pressure is too low.
If the inlet hose is properly connected and the water tap is opened.
If the filtering screen of inlet valve is blocked by dirt.
If the coil of inlet valve is damaged. (The slight electromagnetic
sound is normal phenomenon when the inlet valve is switched on)
If the "Start / Pause" button is pressed after the power
switch is pressed.
If the door lid is closed.
If all clothing piled largely at one side of tub or the clothing
is excessively placed.
If the washing machine is not placed in stable condition or it is placed
in inclination state. (The ground is not flat).
If the motor belt is loosened.
Note: During the de spin process, if washing are piled at one side of the spin tub,
it will cause unbalance of spin tub resulting in striking. At this moment, the
computer inside the washing machine will feel this unbalance phenomenon and will
automatically correct it ( fill in water Washing ). However, if unbalance situation is
not removed after continuous three corrections, which means the computer
auto-correction can not resolve the problem. Then the user has to manually and evenly
place the clothing inside the tub to solve the problem.
When the washing machine is in trouble, please contact Customer Care Executive at given
Customer Care Number of our company and the customer should not dismantle the machine
without permission.
If the washing machine can not work normally, or appear abnormity or alarms, please check and
correct as follows.
If the water drain hose is placed very high.
If the end of water drain hose is sealed in pond.
If the internal rubber ring of drain valve is blocked by dirt.
If the power is off or the fuse is burned out.
If the power supply voltage is too low.
If the water amount reaches to the required water level.
(The washing machine will not work if the water amount does not
reach the required water level)
17
Malfunction display and solutions
When the washing machine is in trouble, please contact Customer Care Executive at given
Customer Care Number of our company and the customer should not dismantle
the machine without permission.
If the washer can not work normally, and the abnormal indication is shown in the nixie
tube window or the machine alarms, please check and correct as follows.
18
Technical specifications
230V/50Hz
Rated Power Supply
340W
Rated Power
6.0kg
Rated Washing Capacity
6.0kg
Rated Spin Capacity
Product Dimensions(W x D x H)
Application Water Pressure
29kg
Net Weight
0.1MPa~0.6MPa
NA-F60L5WRB
Model
515 x 525 x 900mm
Fault
Cause of fault
Indication
Alarm of the
buzzing sound
Stopping
alarm
Alarm for
water inlet
Imbalance
alarm
Alarm for
opening lid
Drain alarm
Water injection for
about 16 minutes, but
do not reach preset
water level
Checked imbalance
for the third time.
Open the lid when the
washer is spinning
After draining for 4
minutes, does not
finish draining.
The lights of
Normal, Jeans
Soak and 44L,
48L flare.
The lights of Bed
Sheets, Gentle
Wash Rinse and
24L, 29L flare.
The lights of
Quick, Delicate
,Wash and34L,
39L flare.
The lights of Tub
clean, Air dry
, Spin and
15L, 19L flare.
The buzzer goes on
buzzing for 6
seconds. If the fault
is not solved, buzzes
again for 6 seconds
in every 16 minutes.
Open the lid to
deal with faults,
then close the
lid to stop the
alarm.
To Next Page
Loading...
Need help?
General