66
Washing
Preparation: ● Check whether the washing machine has been properly installed. (P.12)
●Turn on the water faucet.
1
After loading the laundry,
turn the power on.
2
According to the type of laundry and soil,
select the course.
e.g.) Normal course
■
For reservation (P.4)
After selecting the course,
select how many hours later you wish
to complete the entire operations.
(Indications other than “Reserve” turn off
in 2 minutes after start.)
●
After reservation is set
•
Change or cancel
→
Press “Off” and do the procedure again.
•
Check the course
→ Press “Program”.
•
Check the reservation time
→ Press “Reserve”.
•
Check the water level
→ Press “Water Level”.
3
Start.
The pulsator operates without water
and measures the load.
(approx. 5 seconds)
●
When Quick course is selected, the
water level is displayed immediately.
Water level indication
(approx. 5 seconds)
Remaining time indication
●
To check the water level
→ Press “Water Level”.
Water begins to be supplied.
NOTE
●
When powdered detergent is poorly soluble, dissolve in
warm water before putting in.
Water of approx. 30 °C
(approx. 5 L)
•
Put in the detergent little by
little while stirring to prevent
it from getting hard or
remaining in a powder state.
●
If there are many thick or large clothes (jeans, sheets, etc.)
in the tub, the detergent may remain dissolved. Dissolve
the detergent according to the above method, or reduce the
amount of laundry.
●
If excessive bubbles form, reduce the amount of detergent
or change the detergent.
4
According to the water level,
put in the detergent.
(Follow the instruction
described on each
detergent’s container.)
Put in the powdered
synthetic detergent
Softener (P.7)
Liquid detergent
●
Dilute sticky type
of detergent with
water before putting
in.
5
Close the lid.
The operation is complete with the
buzzer sound.
For reservation Select the course.
Turn the power on.
Start.
NA-F706562B5F62B3India.indd6NA-F706562B5F62B3India.indd6 2015/02/1014:53:572015/02/1014:53:57
To Next Page
Loading...
Need help?
General