– 15 –
6. Open the door and take the food out.
The oven lamp will turn on.
7. Close the door.
The oven lamp will turn off and 1 minute later the Digital Display Window will go
blank.
Note: While heating, one touch on Stop/Reset Pad or opening the door will cancel
the heating program.
I. To Read the Cycle Counter
To display all cooking times ever used.
1. Open the door and leave it open.
The oven lamp will turn on. “0” will appear in the display.
2. While touching Start Pad, touch Number Pad “3”.
All the cooking times that were ever used will appear.
To display the cumulative number of times the oven was used.
1. Open the door and leave it open.
The oven lamp will turn on. “0” will appear in the display.
2. While touching Start Pad, touch Power Level Selector Pad.
The Number of cycles that the oven has been used will appear.
Note:
The last two digits are dropped from the cumulative number of times the
oven was used which is displayed in units of 100 when used over 100 times.
J. To Activate Program Lock
1. Make sure the oven is plugged into a properly earthed electrical outlet.
2. Open the door and leave it open.
The oven lamp will turn on. “0” will appear in the display. While touching Start
Pad, touch Prog Pad until the display show “PROG”, “P” and “L” (for more than
2 seconds).
3. Program Lock feature is now activated.
Note: In “Program Lock”
a. The oven is started by touching the desired Memory Pad. There is no need to
touch the Start Pad.
b. The Interrupt feature is deactivated—opening the door cancels the remaining
time on the program.
c. The oven can not be programmed or run manually until the Program Lock feature
is deactivated.
K. To Deactivate Program Lock
1. Make sure the oven is plugged into a properly earthed electrical outlet.
(Continued on next page.)
To Next Page
Loading...
Need help?
General
