Panasonic NI-WL600 User Manual

HOW TO ENERGIZE THE IRON _
To maintain the temperature at the selected level, the iron must be energized while it rests
securely on the Power Base. The Power Base is also the intended rest place for the iron.
AWARNING
When you need to set the iron down, the iron must be placed only on the Power Base.
Placing it on fabrics while hot can cause the fabric to scorch or burn, which can cause a fire.
■ Use only electric iron model NI-WL600 with this power base.
■ Hot surface/hot support rollers. Do not touch after iron is energized.
HOWTO CONTROL TEMPERATURE
- ► How to operate the Temperature Control Pad("SET" Pad)
NOTE: All the lights will turn off once the iron leaves the Power Base. They will turn on again
when the iron is re-placed.
HOW TO USE AS A STEAM IRON
1. Fill iron with water. See section " HOW TO FILL WITH WATER H .
2. Plug the cord into a standard 120V- 60Hz electrical outlet.
3. Set the iron on the Power Base securely. The green 11 OFF 1 1 light will turn on.
NOTE: If the green light does not turn on, replace the iron on the Power Base
again, otherwise the Temperature Control Pad cannot function.
4. Push the 11 SET 1 1 Pad to the corresponding temperature level. The red light starts blinking.
-7-

Panasonic NI-WL600 Specifications

General

Type	Dry & Steam iron
Product color	Grey, Silver, Transparent
Soleplate type	Stainless Steel soleplate
Variable steam	Yes
Angle of rotation	360 °
Water tank capacity	0.118 L
Steam boost performance	- g/min
Number of temperature settings	3
Iron power	1500 W
AC input voltage	120 V
AC input frequency	60 Hz
Non-twisting cord	-