2726
USER MANUAL
PANDORA DXL 0110L CAR SERVICE-SECURITY SYSTEM
Enabling radio tag:
The Beeper will emit a long sound signal after entering the level. The system
will wait for action. Press VALET button once to enable radio tag. The system
will confirm enabling with one short sound signal of the siren/Beeper. After
that the system will return to the programming menu. Switch on the ignition
to exit programming mode
Level 16 – Updating built-in Bluetooth modem firmware
Download the firmware from www.pandorainfo.com and install Pandora
BT application on your mobile device (Android version 4.4 or higher with
Bluetooth 4.0 Low Energy or higher support).
To update firmware of the built-in Bluetooth modem, enter the
programming mode and press VALET button 16 times. Find your system in
the mobile application, go to detected devices and upload the previously
downloaded firmware to the system.
Level 18 – Registration and deleting a mobile device
The system supports only one mobile device. Registration of a new mobile
device (if the system has previously registered device) is not allowed without
deleting procedure.
When you overwrite the same device in the system memory, you should
delete the Bluetooth connection on your mobile device, delete the mobile
device from the system memory and then register the mobile device in the
system memory.
To register a mobile device, enter the programming mode and press VALET
button 18 times. The LED indicator will light green (green light indicates the
system is ready to register a mobile device) and the system will enter the
mobile device registration mode. Red light of LED indicates the system has
already had registered mobile device, overwriting of mobile device can be
done only after deleting procedure.
• Mobile device registration:
The LED indicator will light green after entering the level. Open the mobile
application and press «Search device» button. The application will search for
the system via Bluetooth connection. Select the found system, the system and
the mobile device will be automatically paired. The system will confirm the
pairing with a sound signal of the siren/Beeper and red flash of LED indicator.
• Deleting mobile device:
The LED indicator will light red after entering the level. Press VALET button
and hold it for more than 4 seconds, release the button. The system will confirm
deleting with the series of sound signals of the siren/Beeper and the system
will return to mobile device registration mode (LED indicator will light green).
• Save changes:
To finish the registration of a mobile device into the system, VALET button
should be pressed once, the series of red and green flashes of the status LED
indicator with the series of the sound signals of the Beeper will confirm the
saving, switch on the ignition to automatically save the settings and exit the
programming mode.
Level 19, 20 – Updating radio relays №1, №2 rmware
Download the firmware from www.pandorainfo.com and install Pandora
BT application on your mobile device (Android version 4.4 or higher with
Bluetooth 4.0 Low Energy or higher support).
To update firmware of radio relays 1, 2, enter the programming mode
and press VALET button 19 times for radio relay 1 and 20 times for radio relay
2. Find your system in the mobile application, go to detected devices and
upload the previously downloaded firmware to the system.
To Next Page
Loading...
Need help?
General
