Wireless network connection type is divided into basic structure mode and Wi-Fi Direct
mode. If you have problems with wireless network setup, please refer to Chapter 5.3
Wireless Network Setup FAQs.
Basic structure mode: connecting to a
wireless device via router
1. Access point (wireless router)
2. Wireless network printer
3. Computer connecting to access point via
wireless network
4. Computer connecting to access point via
network cable
Wi-Fi Direct mode: wireless client is
connecting to a printer with Wi-Fi function
1. Wireless network printer
2. Wireless client is directly connecting to a
wireless network printer
5.1.Basic structure mode
You can connect a computer to your printer via access point (wireless router) as the medium.
Access point (wireless router) connection is divided into wireless network setup and Wi-Fi
Protected Setup (WPS).
Important:Beforewirelessnetworkinstallation,youmustlearnabouttheservicesetidentifier
(SSID) and password of your access point in order to use them during wireless network
setup. If they cannot be determined, please consult your network administrator or access
point (wireless router) manufacturer.
5.1.1.Wireless network setup tools
If your computer has been installed with a driver and had been connected to wireless
network, but the wireless network was changed, you can set it again with wireless network
setup tools.
5.1.1.1.Preliminary preparations
1. Access point (wireless router).
2. A computer that has been connected to network.
3. A printer that has wireless network function.
5.Wireless network setup (applicable to Wi-Fi models)
To Next Page
Loading...
Need help?
General