Paradox RTX3 User Manual

Programming Page 17
Programming Stand-Alone RTX3 Modules
The RTX3 can be used as a Stand-Alone module. This section describes how
to program the RTX3 in Stand-Alone mode.
Requirement
Use a PX8 in conjunction with the RTX3 to program wireless transmitters in
Stand-Alone mode (see the PX8 Instructions for more information).
To enter Programming mode:
1. Connect a 636 or 646 keypad to the Program connector (see #8 in
Figure
1on page5
).
2. Press the Mode Programming button (see #7 in
Figure 1 on page 5).
3. Press [ENTER] on the Esprit keypad.
4. Enter the installer code (default: 757575).
5. Enter the required section number.
Stand Alone Programming
Section Feature Details
[000] Installer Code Set installer code (4 or 6 digits. Default:
757575)
[004]
PGM Initial State
Option
[6]
PGM1 initial
state
OFF: Normally open (default)
ON: Normally closed
[7]
PGM2 initial
state
OFF: Normally open (default)
ON: Normally closed
[201] to
[232]
Remote Control
Assignment
Sections [201]-[232] correspond to
remote Controls 1- 32
To assign a remote control:
1. Press [ENTER].
2. After the confirmation beep, press
and hold any button on the remote
until you hear two beeps.
To delete a remote control:
Press [2ND] followed by [ENTER].

Paradox RTX3 Specifications

General

Brand	Paradox
Model	RTX3
Category	Computer Hardware
Language	English