Programming Page 9
Chapter 2: Programming
This section describes how to program the RTX3 for Spectra SP series
control panels, EVO series control panels and for stand-alone installations.
Programming RTX3 for Spectra SP Series Panels
When connected to a Spectra SP Series control panel, RTX3 settings are
programmed through control panel programming sections. For detailed
instructions refer to the Spectra SP Series Programming Guide.
Notes:
• Programming for a Spectra SP series system requires K32 or K10V/H
keypads v2.0 or higher
• Only one RTX3 module can be connected to a Spectra SP Series panel
Programming for EVO Series Panels
Program RTX3 settings for EVO panels with either a keypad or BabyWare PC
software.
Programming RTX3 with a Keypad
When connected to an EVO panel, program RTX3 settings through the
keypad by entering Module Programming Mode.
To enter Module Programming mode:
1. Press and hold the
[0] key.
2. Enter the
[INSTALLER CODE].
3. Enter section
[4003].
4. Enter the module
[SERIAL NUMBER].
5. Enter the required
[DATA].
Note: When used without a K641 or K641R keypad, enable EVO option [1]
in section
[3029].
After Programming RTX3 for EVO Control Panels
Program the zones, PGMs, sirens and remote controls into the EVO panel.
Refer to EVO section [3034] and RTX3 section [001]* options [2] and [3] for
wireless transmitter supervision options. Requirement: Configure all
wireless sirens in an EVO system to a single RTX3.
To Next Page
Loading...
Need help?
General
