NOTES ON EVENTS
The weekday keys 1 - 7 and the holiday key 8 have priority over the
daily key 0. If an ON/OFF event is programmed for an individual
weekday, then all programmed daily events are cancelled for that day
on that channel. For example, if you program a daily On at 8:00 AM
and a daily OFF at 5:00 PM, and then program an ON to occur only
on Wednesday at 10:00 AM, the ON at 8:00 and OFF at 5:00 will be
cancelled out; you will need to program a separate OFF for
Wednesday.
You can program daily events and still skip a day by programming an
event with 0000 for the time on that day. For instance, say that you
want an 8:00 AM ON and 5:00 PM OFF for each weekday, but you
wish to skip both Saturday and Sunday. Program the ON and OFF as
daily events and then program a 0000 event for each Saturday and
Sunday. See Step 3 on page 26. This process, however, cannot be
used if the control has been converted to momentary output; if you
have selected the Momentary Option, there is no way to use the daily
function and also skip any day(s) — all daily events will occur every-
day. In some applications, this can be overcome by external wiring.
See page 42.
OVERRIDE
To initiate override, the control must be in the RUN mode. Press C1
and/or C2 to override desired channel from ON to OFF, or OFF to
ON. Channel remains in that state until overridden again or until the
next opposite programmed event. If control has been converted to
momentary output, initiating override will energize the relay(s) for two
seconds.
29
To Next Page
Loading...
Need help?
General
