Parkside PSS 270 C3 User Manual

PSS 270 C3
GB
│
IE
│
7 ■
Dust extraction using an external extraction
device
Connection
♦ To remove dust using a vacuum cleaner, push
the suction hose of a suitable dust extraction
device (e.g. a workshop vacuum cleaner) onto
the nozzle5.
NOTE
► If necessary, use the adapter6 by pushing it
into the nozzle5.
Removal
♦ Pull the hose of the vacuum cleaner off the
nozzle5 or the adapter6.
Work instructions, tips and tricks
♦ Move the sheet sander parallel to the surface
and in a flat circular motion or alternatively
lengthwise and across the surface.
♦ Do not press down hard on the sheet sander.
The sanding sheets will get clogged and the
sanding performance will deteriorate.
♦ Clean the sanding sheet0 every once in a
while using a vacuum cleaner.
♦ The proper choice of sheet speed and grain of
the sanding sheet0 will determine the removal
rate and thus also the result of your work.
♦ Never use the same sanding sheet0 for
sanding different materials (e.g. wood and
then metal).
In the table below, you will find some recommended
values that will help you determine which sanding
sheet0 to use for which job.
Wood
Sanding
sheet/grain
Working on wood 40–240
Pre-sanding, e.g. of unfinished,
unplaned beams and planks
40, 60
Surface sanding 80, 100, 120
Fine sanding of hardwoods 180, 240
Paint/varnishes
Sanding
sheet/grain
Working on coats of paint/
varnish or primers such as
filler
40–320
Removal of paint 40, 60
Sanding undercoat 80, 100, 120
Final sanding of primers before
painting
180, 240,
320
Maintenance and cleaning
WARNING! RISK OF INJURY!
► Always remove the plug from the mains power
socket before carrying out any work on the
tool.
■ Always clean the tool as soon as you finish your
work.
■ Do not use any sharp objects to clean the tool.
Do not allow any liquids to get into the tool.
■ Use a dry cloth to clean the housing. Never
use petrol, solvents or cleaning agents that can
damage plastic. A vacuum cleaner is required
to clean the tool thoroughly.
■ Ventilation openings must never be obstructed.
■ Remove any adhering sanding dust with a
brush.

Parkside PSS 270 C3 Specifications

General

Brand	Parkside
Model	PSS 270 C3
Category	Sander
Language	English