11GB
Enabling/disabling the automatic
power-off function
When the product is switched on, press and hold [4]
for approx. 2seconds to enable or disable the automatic
power-off function.
When the automatic power-off function is enabled,
[8] is shown on the display[3]. In this case, the
product switches off automatically if no button has been
pressed for approx. 20minutes.
Turning the backlight on or off
When the product is switched on, press and hold [6]
for approx. 2seconds to turn the backlight on or off.
Selecting the unit of measurement
Press UNIT[5] to enter the setting mode. SET[] is
shown on the display[3].
The wind speed unit m/s[] flashes on the display[3].
This means, that this unit is selected.
Repeatedly press UNIT[5] to toggle between the
available units.
When the desired unit flashes on the display[3], stop
pressing UNIT[5]. After 2seconds, the selected unit is
saved automatically. The product returns to measurement
mode.
Positioning the product/Taking a
measurement
When the product is switched on, hold and position the
product so that the airflow to be measured enters the
vane[1] from the rear side of the product.
For more accurate results, try to keep the axis of the
vane within 20° of the wind direction. The airflow being
measured must have direct and unhindered access to the
vane without any obstacles in between.
Wait for approx. 5seconds. The display[3] shows the
wind speed together with the current temperature.
The display[3] shows Hi when the measured
temperature is higher than +50°C (+122°F).
The display[3] shows Lo when the measured
temperature is lower than –10°C (+14°F).
The display[3] shows OL when the measured wind
speed exceeds 30m/s (108km/h, 5906ft/min,
67.2mph, or 58.32knots).
Using the data hold function
(freeze)
In measurement mode, briefly press HOLD[6] to freeze
the current readings on the display[3]. The display
shows H [].
Press HOLD[6] again to return to measurement mode.
H [] goes off in the display[3].
To Next Page
Loading...
Need help?
General
