2 3
EN – Operating instructions QEM / QET
2. GENERAL INFORMATION
This manual must always accompany the relevant equipment and be conserved in an accessi-
ble location for consultation by qualied technicians assigned for operation and maintenance
of the system.
The installer/user is strongly recommended to read carefully all instructions and information
in this manual before using the product, in order to avoid damage or improper use of the unit,
which would also aect the warranty as null and void.
Before operating the equipment, carefully read the manual and follow all instructions herein.
The information and instructions in this manual refer to the standard use of this product; in
the event of special circumstances, functions or applications not described in this document,
contact our service centre for assistance.
If technical assistance or spare parts are required, when contacting the manufacturer always
specify the identication code of the model and construction number as stated on the data
plate.
Our service centre is available for any requirement or clarication.
The electrical equipment supplied must be installed indoors in a well-ventilated environment,
within a temperature range of -5° to +40°C.
3. WARNINGS
On receipt of the goods, perform an inspection immediately to ensure that the equipment has
not been damaged during transport.
The QEM/QET electrical panels must be used exclusively for the purpose and function as spe-
cied in design. Any other application or use is to be considered improper and therefore ha-
zardous.
DANGER
All QEM/QET panel installation and maintenance operations must be perfor-
med by a specialized technician who is fully aware of the relevant current
safety standards.
Always disconnect the unit from the power supply before maintenance or cleaning.
If QEM/QET is not used for prolonged periods, store the product in a clean and safe location
protected against atmospheric agents and the potential risk of dropping/falling.
DANGER
In the event of a re in the place of installation or the surrounding area,
avoid the use of water jets and use the appropriate extinguishing equip-
ment and means (powder, foam, carbon dioxide).
WARNING
Install the equipment far from heat sources and in a dry and sheltered loca-
tion in observance of the stated protection rating (IP). The installation of a
safety device is recommended to protect the panel power line in complian-
ce with current electrical standards.
To Next Page
Loading...
Need help?
General