Color Sync Controller Installation Guide
14
15
TURN power OFF at circuit breaker - Always disconnect power to
the pool light at the circuit breaker before servicing the light. Failure
to do so could result in death or serious injury to installer, service
person, pool users, or others due to electrical shock.
5. Install the new gasket: Place the gasket behind the face plate flush
against the back of the face plate as shown below.
6. Reconnect the three (3) wires to the connector screw terminal as shown
on page 12.
Controller Gasket Rear View
3 wire connector
screw terminal
Gasket
Face plate
7. Using the provided grease, lubricate the two screw threads.
8. Secure the controller in the outlet box with the two front screws.
Screw (x2)
Gasket
Lubricate
screw threads
COLOR SYNC CONTROLLER MOUNTING KIT REPLACEMENT
To Next Page
Loading...
Need help?
General
